Tormach CNC Plasma Cutter Debugging: Difference between revisions
From Pumping Station One
Makelemonade (talk | contribs) No edit summary |
Known issue with MrFluffles |
||
| Line 8: | Line 8: | ||
# Is the "Machine OK" status light on? | # Is the "Machine OK" status light on? | ||
# Did you reference X, Y and Z? | # Did you reference X, Y and Z? | ||
Known issue with MrFluffles as of May 4 2023 | |||
The post processor is adding feed speeds and a dwell command after the M200 command. This overrides these settings of the AutoFS stock picker in Pathpilot. | |||
If you picked the correct tool for your material in Sheetcam this shouldn't be an issue. | |||
However, using the same Gcode for different materials will likely lead to less-than-optimal cuts. | |||
