Tormach 1300PL CNC Plasma Cutter: Difference between revisions
From Pumping Station One
Adding step by step instructions |
mNo edit summary |
||
| Line 43: | Line 43: | ||
Click the X,Y & Z Zero buttons.<br/> | Click the X,Y & Z Zero buttons.<br/> | ||
Select your material using the auto F&S selector drop downs. Note the amps required setting in the pop up window.<br/> | Select your material using the auto F&S selector drop downs. Note the amps required setting in the pop up window.<br/> | ||
==== Hypertherm Plasma setup ==== | ==== Hypertherm Plasma setup ==== | ||
Turn on Hypertherm machine at the back of the Tormach, you should see three green lights.<br/> | Turn on Hypertherm machine at the back of the Tormach, you should see three green lights.<br/> | ||
Check that Hypertherm Amps setting matches the amps required setting in the Pathpilot pop up window, adjust as necessary.<br/> | Check that Hypertherm Amps setting matches the amps required setting in the Pathpilot pop up window, adjust as necessary.<br/> | ||
==== Run your job ==== | ==== Run your job ==== | ||
If you haven’t already, load your Gcode, click the reset button if flashing.<br/> | If you haven’t already, load your Gcode, click the reset button if flashing.<br/> | ||
| Line 55: | Line 55: | ||
Run Job. Click cycle start.<br/> | Run Job. Click cycle start.<br/> | ||
*Be prepared to click stop or hit Estop if something seems wrong*<br/> | *Be prepared to click stop or hit Estop if something seems wrong*<br/> | ||
==== Shut Down ==== | ==== Shut Down ==== | ||
Set the Hypertherm plasma to 45 amps if needed and turn off the machine.<br/> | Set the Hypertherm plasma to 45 amps if needed and turn off the machine.<br/> | ||
