Tormach 1300PL CNC Plasma Cutter: Difference between revisions
From Pumping Station One
Tachoknight (talk | contribs) |
Tachoknight (talk | contribs) |
||
| Line 15: | Line 15: | ||
== Description == | == Description == | ||
Will fill this in later. | Will fill this in later. | ||
== Maintenance == | |||
(Shamelessly copied from page 58 in the manual) | |||
=== Daily === | |||
* Clean the machine of any dust or abrasive particle buildup with a vacuum and brushes. | |||
* Wipe dust off of the linear rails with a clean cloth. | |||
=== Weekly === | |||
* Clean all exterior surfaces with a mild cleaner. | |||
* Examine the water table's level and, if necessary, add water / rust inhibitor (GreenCut). | |||
* Check your plasma torch consumables for wear and replace if needed. | |||
=== Monthly === | |||
* Clean the electrical cabinet vents of dust with a clean cloth or compressed air. | |||
* Remove the slats and clean sediment buildup from the bottom of the water table. | |||
=== Semi-Annually === | |||
* Check drive belts for wear and re-tension if needed. | |||
* Remove faceplate from torch lifter and clean lead screw with a lint-free cloth. | |||
== Status == | == Status == | ||
