DoAll Bandsaw: Difference between revisions
From Pumping Station One
m My authorization |
m add major components gallery |
||
| Line 37: | Line 37: | ||
|- | |- | ||
|} | |} | ||
== Major Components == | |||
<gallery> | |||
File:doall-bandsaw-power-plug.jpg|The 4-prong, twist-lock power plug; note the band of purple tape | |||
File:doall-bandsaw-power-cutoff.jpg|The power cutoff switch, in the 'off' position; the power cutoff needs to be in the 'on' position before the machine will turn on | |||
File:doall-bandsaw-power-control-panel.jpg|The power control panel; note the on button (upper left), off button (upper right), and key switch (bottom; pictured in the upright, locked); the key switch needs to be unlocked (turned to the right) before the on button will turn the machine on | |||
File:doall-bandsaw-cut-parameter-chart.jpg|The cut parameter chart, listing blade speeds & pitch for different materials & thicknesses | |||
File:doall-bandsaw-speed-dial.jpg|The blade speed dial, which should be set according to the the proper cut parameters found in the chart | |||
File:doall-bandsaw-gear-selector-knob.jpg|The gear selector knob, in 'high' gear, for coarse control of the blade speed | |||
File:doall-bandsaw-speed-selector-wheel.jpg|The speed selector wheel, for fine control of the blade speed | |||
File:doall-bandsaw-table.jpg|The tilting table, in the horizontal position | |||
File:doall-bandsaw-table-tilt-lock-wheel.jpg|The table tilt lock wheel, in the 'locked' position'; the table's angle can be changed when the wheel is unlocked, and then fixed again in place | |||
File:doall-bandsaw-blade-guide.jpg|The blade guide; its height above the table is controlled by the positioning wheels | |||
File:doall-bandsaw-blade-guide-positioning-wheels.jpg|The blade guide positioning wheels: height adjustment (top) and lock (bottom) | |||
</gallery> | |||
== Auth/Use Notes == | == Auth/Use Notes == | ||
