ER25 Tooling: Difference between revisions
From Pumping Station One
m Mct moved page ER25 Collet Set to ER25 Tooling: added more stuff |
m update kit contents |
||
| Line 1: | Line 1: | ||
A | A set of ER25 tooling. | ||
{{Template:EquipmentPage | {{Template:EquipmentPage | ||
| Line 6: | Line 6: | ||
|certification = no | |certification = no | ||
|hackable = no | |hackable = no | ||
|model = 3900-5235 | |model = 3900-5235 (collet set) | ||
|serial = 69053 02866 | |serial = 69053 02866 (collet set) | ||
|arrived = | |arrived = 2018-02-24 | ||
|where = [[Bridgeport Knee Mill#In the Large Mill Accessories Cabinet|Large Mill Accessories Cabinet]] | |where = [[Bridgeport Knee Mill#In the Large Mill Accessories Cabinet|Large Mill Accessories Cabinet]] | ||
|doesitwork = yes | |doesitwork = yes | ||
|contact = [[User:mct|McTavish McArdle]] | |contact = [[User:mct|McTavish McArdle]] | ||
|value = $ | |value = $200 | ||
|image = er25- | |image = er25-tooling-set.jpg | ||
}} | }} | ||
= Contents = | |||
This tooling set includes: | |||
* A 15-piece set of ER25 collets, in 1/16" increments, from 1/16" to 5/8" (the full range of the collet size) | |||
* Two ER25 collet blocks; for both blocks, the nut is larger than the block diameter, so careful work holding is needed | |||
** A square collet block, 35mm across & ~42mm tall | |||
** A hex collet block, 35mm across (minor diameter) & ~42mm tall | |||
* An ER25 collet holder, with an integral R8 taper | |||
** ''[Note that the runout on this collet holder is rather horrific, and it will need to be reground before it will be useful]'' | |||
* An ER25 collet nut spanner (affixed by magnets to the inside top of the box) | |||
[[Category:Loaned Equipment]] | [[Category:Loaned Equipment]] | ||
