Talk:BOSS LS-3655 150w Laser Engraver: Difference between revisions

Browse history interactively

← Older edit Newer edit →

VisualWikitext

@@ Line 1: / Line 1: @@
+I think there is too much emphasis here on settings and not on broad topics of how to use the software and hardware.
+People are getting angry that this machine is sitting there and there hasn't been a process approved by the area host for conducting authorizations.
+We need to work out in very short order what needs to be conveyed to a user for safe and effective operation, emphasis on the safety of members, bystanders, the space and the machine.
+Specific things:
+what's up with adjusting the focus at different points on the bed,
+how do you move the head so that the green-box start point can be moved around the bed,
+how do you achieve 1:1 match between the software interface and the bed, is that even possible?
+talk about e-stop procedures and fire safety procedures
+what are special or new considerations for lasering with the Boss that don't apply or didn't apply to the Epilog?
+is there a document yet that anyone has made and could you share it please, with a rough draft for a guide to conducting authorizations?
+if nobody else has one I will write and post a half-baked one based on what I know so far.
+what are the top 3 videos or sites for advice about this stuff? most of the online content I have seen for Boss/RDWorks/Laserwors has been bad, exasperatingly wordy and annoying. I have not found any excellent resources yet. If you have them, post them.
+--[[User:Rdoeksen|Rdoeksen]] ([[User talk:Rdoeksen|talk]]) 11:42, 9 May 2017 (CDT)
 == Questions ==