Epilog 30w Mini 24 Laser Engraver: Difference between revisions
From Pumping Station One
→Top Eight: adding a few big ones |
|||
| Line 20: | Line 20: | ||
* As of 3/24/2014, parts needed have been identified and are ordered, were under warranty, should arrive by 3/26/2015, and are expected to be installed that evening. | * As of 3/24/2014, parts needed have been identified and are ordered, were under warranty, should arrive by 3/26/2015, and are expected to be installed that evening. | ||
== Top | == Top Eight == | ||
* Don't use the autofocus, because it could burn out a motor. | * Don't use the autofocus, because it could burn out a motor. | ||
* Don't cut materials that will ignite or emit dangerous fumes. See section below. | * Don't cut materials that will ignite or emit dangerous fumes (any chlorinated plastic like PVC, for example). See section below. | ||
* Always use the exhaust | * Always use the exhaust fan/always use the air assist on vector cuts. | ||
* You must stay with the job; don't walk away. Things could catch on fire, that would suck. | * You must stay with the job; don't walk away. Things could catch on fire, that would suck. | ||
* Sometimes it's a pain to get the right driver working. http://www.thinkgeek.com/product/11c3/ | * Sometimes it's a pain to get the right driver working. http://www.thinkgeek.com/product/11c3/ | ||
* Do not attempt to service the machine yourself unless you've cleared it with Elizabeth | |||
* Do not touch any settings in the Config menu on the machine itself | |||
* Do not touch any settings in the Maint menu on the machine itself '''''except''''' you may use Maint/1/Return Home to reset the cutting head to the machine's default origin (.015" inside the top left corner as of 4/28/15) | |||
== General Info == | == General Info == | ||
