Talk:MakerBot Replicator: Difference between revisions
From Pumping Station One
No edit summary |
mNo edit summary |
||
| Line 1: | Line 1: | ||
Machine Repaired - Left extruder fan wiring shorted in wire loom causing power cycle when the left thermocouple read 50C+ | |||
Thermocouples were retaped to ensure electrical isolation from heater block - heater wire can fray and short out on the heater block. | |||
5V pin was removed from the end stop cables. This is reversible and protects against internal shorts in the endstop cables. A short could permanently damage the Mightyboard. End stop leds will not work but they still mechanically function as intended. | |||
A plastic cover was added to the back of the lcd to prevent accidental damage from grabbing bare conductors. --[[User:Junes|Junes]] ([[User talk:Junes|talk]]) 15:59, 28 October 2014 (CDT) | |||
September 22, 2014: Machine reboots when it heats up. | September 22, 2014: Machine reboots when it heats up. | ||
