LulzBot AO-100 3D Printer: Difference between revisions
From Pumping Station One
m Robot: Cosmetic changes |
Hypertaxia (talk | contribs) |
||
| Line 40: | Line 40: | ||
Data rate = 115200 | Data rate = 115200 | ||
Temperature (degrees C) | |||
Extruder: 230 | |||
Bed: 110 | |||
Lulzbot's slic3r config has the infill density set at 0.75. Resulting prints are very sturdy as a result, but the filament consumption and print time go up because of this. It is recommended to turn it down to 0.15 or 0.25, and to increase the number of infill shells. Doing so should have a similar surface quality, but produce a print with significantly less mass. | Lulzbot's slic3r config has the infill density set at 0.75. Resulting prints are very sturdy as a result, but the filament consumption and print time go up because of this. It is recommended to turn it down to 0.15 or 0.25, and to increase the number of infill shells. Doing so should have a similar surface quality, but produce a print with significantly less mass. | ||
