LulzBot AO-100 3D Printer: Difference between revisions
From Pumping Station One
| Line 33: | Line 33: | ||
=== Suggested Settings === | === Suggested Settings === | ||
Nozzle diameter = 0.5 mm | Nozzle diameter = 0.5 mm | ||
Filament diameter = 3.0 mm | |||
Lulzbot's slic3r config has the infill density set at 0.75. Resulting prints are very sturdy as a result, but the filament consumption and print time go up because of this. It is recommended to turn it down to 0.15 or 0.25, and to increase the number of infill shells. Doing so should have a similar surface quality, but produce a print with significantly less mass. | Lulzbot's slic3r config has the infill density set at 0.75. Resulting prints are very sturdy as a result, but the filament consumption and print time go up because of this. It is recommended to turn it down to 0.15 or 0.25, and to increase the number of infill shells. Doing so should have a similar surface quality, but produce a print with significantly less mass. | ||
