Talk:Laser Cutter Instructions and Workflow: Difference between revisions
From Pumping Station One
Question re: auto focus |
No edit summary |
||
| Line 1: | Line 1: | ||
=== Configure Laser Settings >> Enable Auto Focus === | |||
Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time? | Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time? | ||
--[[User:Jaypee|Jaypee]] ([[User talk:Jaypee|talk]]) 15:32, 5 November 2013 (CST) | --[[User:Jaypee|Jaypee]] ([[User talk:Jaypee|talk]]) 15:32, 5 November 2013 (CST) | ||
I heard some disagreement over auto focus when I was being certified, so it's reasonable that there'd be differing instructions scattered around. Given that the lazor was temporarily out of commission because of an autofocus-induced head crash and Liz is the CNC area host, I went ahead and changed the wording to say "Do '''not''' enable..". [[User:Negativek|Negativek]] ([[User talk:Negativek|talk]]) 15:48, 5 November 2013 (CST) | |||
Revision as of 15:48, 5 November 2013
Configure Laser Settings >> Enable Auto Focus
Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time? --Jaypee (talk) 15:32, 5 November 2013 (CST)
I heard some disagreement over auto focus when I was being certified, so it's reasonable that there'd be differing instructions scattered around. Given that the lazor was temporarily out of commission because of an autofocus-induced head crash and Liz is the CNC area host, I went ahead and changed the wording to say "Do not enable..". Negativek (talk) 15:48, 5 November 2013 (CST)
