Shop Fox 8" Plate Shear: Difference between revisions
From Pumping Station One
fixing broken fields |
No edit summary |
||
| Line 9: | Line 9: | ||
| value = $100 | | value = $100 | ||
| arrived = 2013 | | arrived = 2013 | ||
|image = Shop Fox plate shear.jpg | |||
}} | }} | ||
== Note == | == Note == | ||
Primarily designed for straight cuts in sheet metal. | Primarily designed for straight cuts in sheet metal. | ||
| Line 27: | Line 27: | ||
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut. | Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut. | ||
[[Category:Metalworking]] | [[Category:Metalworking]] | ||
[[Category:Fabrication]] | [[Category:Fabrication]] | ||
Revision as of 01:16, 30 September 2013
 | This tool is currently broken, please contact the area host for more information. |
 | |
| Owner/Loaner | Michael Skilton |
|---|---|
| Serial Number | {{{serial}}} |
| Make/Model | M1040 |
| Arrival Date | 2013 |
| Usability | Working |
| Contact | Michael Skilton |
| Where | Machine Shop |
| Authorization Needed | No |
| Hackable | No |
| Estimated Value | $100 |
| Host Area | {{{hostarea}}} |
Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.
