ShapeOko2 CNC Router: Difference between revisions
From Pumping Station One
Newfatmike (talk | contribs) No edit summary |
Newfatmike (talk | contribs) |
||
| Line 52: | Line 52: | ||
=== Workpiece Setup === | === Workpiece Setup === | ||
* Clamp work to the surface with the toe clamps (in the | * [//https://youtu.be/r6DCvtcU8_M Using blue painter's tape on the bed and underside of the part and bonding the two with superglue is an extremely effective workholding solution.] | ||
** The superglue never touches the bed itself nor the work, just the tape. | |||
* Clamp work to the surface with the toe clamps (in the drawer under the machine.) | |||
** Toe clamps need to be pushing down - so that the toe is angled down towards the workpiece - not angled up. | ** Toe clamps need to be pushing down - so that the toe is angled down towards the workpiece - not angled up. | ||
** After setting the height with the toe's rear bolt, lightly finger-tighten the bolt near the piece. | ** After setting the height with the toe's rear bolt, lightly finger-tighten the bolt near the piece. | ||
