ShapeOko2 CNC Router: Difference between revisions
From Pumping Station One
NewFatMike (talk | contribs) No edit summary |
NewFatMike (talk | contribs) Adding Fusion 360 Post Processing |
||
| Line 54: | Line 54: | ||
** If the bit is too deep in the collet, it can bottom out inside the spindle when you begin to tighten the collet. | ** If the bit is too deep in the collet, it can bottom out inside the spindle when you begin to tighten the collet. | ||
* Use 14mm wrenches (in the black bag) to tighten the collet. You don't need to over-tighten the collet - hand tighten, not gorilla tighten. | * Use 14mm wrenches (in the black bag) to tighten the collet. You don't need to over-tighten the collet - hand tighten, not gorilla tighten. | ||
===Using Fusion 360=== | |||
You will need to install the Easel post processor in order to get usable GCode from Fusion 360 to the Shapeoko. The post processor is available here: | |||
https://cam.autodesk.com/hsmposts?p=easel | |||
When using Universal GCode Sender, you will get a "HOLD" error because it leads with a tool change (M6). The Shapeoko does not support a tool change command, and so simply hitting the "Play" button again will resume operation. | |||
=== Carving with Easel === | === Carving with Easel === | ||
