Jointer Grizzly 8 inch: Difference between revisions
From Pumping Station One
Garynhouse (talk | contribs) Created page with "{{Template:EquipmentPage |owner = PS1 |certification=yes |hackable = NO |model = Grizzly G0495X |serial = NA |arrived = DEc 2019 |doesitwork = yes |contact = Wood Shop Area H..." |
Garynhouse (talk | contribs) No edit summary |
||
| Line 6: | Line 6: | ||
|serial = NA | |serial = NA | ||
|arrived = DEc 2019 | |arrived = DEc 2019 | ||
|doesitwork = | |doesitwork = no | ||
|contact = Wood Shop Area Host | |contact = Wood Shop Area Host | ||
|where = Wood Shop | |where = Wood Shop | ||
| Line 15: | Line 15: | ||
== Status == | == Status == | ||
Oot of order due to dust collector sensor blow. part ordered 6/28, to be installed before 7/5/2022 | |||
The danger committee has approved opening the tool for use on Jan 16, 2020. all previously authorized users will be grandfathered | The danger committee has approved opening the tool for use on Jan 16, 2020. all previously authorized users will be grandfathered | ||
Revision as of 19:01, 30 June 2022
 | This tool is currently broken, please contact the area host for more information. |
 | |
| Owner/Loaner | PS1 |
|---|---|
| Serial Number | NA |
| Make/Model | Grizzly G0495X |
| Arrival Date | DEc 2019 |
| Usability | no |
| Contact | Wood Shop Area Host |
| Where | Wood Shop |
| Authorization Needed | yes |
| Hackable | NO |
| Estimated Value | $525.00 |
| Host Area | Wood Shop |
Status
Oot of order due to dust collector sensor blow. part ordered 6/28, to be installed before 7/5/2022
The danger committee has approved opening the tool for use on Jan 16, 2020. all previously authorized users will be grandfathered
This tool requires authorization for use.
Rules
- Always check your wood for nails or staples. If you're not sure, check the entire piece with the metal detector or a magnet.
- Remove the smallest amount of material possible and feed it at an appropriate speed. More passes are better than fewer. If you don't know how to properly adjust the infeed table, ask for help.
- Always use the vacuum while running the jointer. Otherwise, it will clog with chips.
- If you break something, or damage the tool, contact the area host immediately. Don't let others do more damage to the machine, ruin their work, or hurt themselves by using a broken tool.
- Always vacuum the machine, cutting area, and the table around the machine when you are done.
