Prusa i3 MK2S .202: Difference between revisions

Browse history interactively

← Older edit Newer edit →

VisualWikitext

@@ Line 32: / Line 32: @@
 == Operation ==
-=== [[Prusa i3 OctoPrint Server]] ===
+===Preparr the Printer===
+====''1. Clean the nozzle''====
-The Prusa i3 MK2S printer at IP address 10.100.1.203 uses OctoPrint as its host device. Enter that IP address into your web browser, via any computer/device on the PS1 network, to send jobs to the .203 printer.
+put info here
-'''Note:''' the other two i3 3D printers (at 10.100.1.202 and .204) do not use OctoPrint. For those two printers, you must manually load your .STL files on a SD Card on a computer, then load the SD card in one of those printers.
+====''2. Load material spool''====
+put info here
+====''3. Clean the bed''====
+put info here
+====''4. Set printer settings for your job''====
+put info here
+===Prepare Your .STL file===
+Put info about Prusa Slicer here...
+===Upload & Print Your .STL File===
+====''The Prusa i3 MK2S printers at IP address 10.100.1.202 and 10.100.1.204''====
+. Load your .STL file onto an SD card (some are provided at PS1).
+. Insert SD card into printer.
+. Then...[put info here]
+====''The Prusa i3 MK2S printer at IP address 10.100.1.203''====
+This printer uses the [[Prusa i3 OctoPrint Server]] as its host device. Enter that IP address into your web browser, via any computer/device on the PS1 network, to send jobs to the .203 printer.
+''Connecting to OctoPrint (.203 Printer Only)
+Open a web browser connected to a computer/device on the PS1 network & enter 10.100.1.203 in the IP address field.
 * When connecting to the OctoPrint server, you may first need to select "Connect" under the left side Connection tab if the printer has been turned off.