Evenheat 810 Kiln: Difference between revisions

Browse history interactively

← Older edit Newer edit →

VisualWikitext

@@ Line 12: / Line 12: @@
 |image=Evenheat-810-kiln.jpg
 }}
+== Major Components ==
+<gallery>
+File:Evenheat-810-temperature-controller-plug.jpg|The temperature controller's power plug.
+File:Evenheat-810-power-controller.jpg|The temperature controller's power switch; the kiln's power plug is plugged into the outlets, to the left of the switch, and should not be unplugged.
+File:Evenheat-810-temperature-control-panel.jpg|The temperature controller's control panel; the current temperature will display in the top readout, in red, while the target temperature will display in the bottom readout, in green; the up & down chevron buttons below the display change the target temperature.
+File:Evenheat-810-thermocouple-port.jpg|The kiln's thermocouple port, with the thermocouple inserted.
+File:Evenheat-810-thermocouple-tip.jpg|The tip of the kiln's thermocouple, on the other side of the port.
+File:Evenheat-810-thermocouple-connection.jpg|The connectors where the thermocouple leads plug into the temperature controller; the '+' lead of the thermocouple should plug into the '+' jack, and the '-' lead should plug into the '-' jack.
+File:Evenheat-810-kiln-controller.jpg|The kiln's main controller. The two switches should be in the 'on' position (pictured, 'off') to power the heating coils; when powered, the light below the upper switch will glow orange; the main power cutoff (pictured in the 'off') position; is above the lower switch.
+File:Evenheat-810-main-cutoff-on.jpg|The kiln's main power cutoff, in the 'on' position; note how the button is pushed in, and the lever is pulled slightly upward.
+</gallery>
 == History ==
@@ Line 32: / Line 45: @@
 * [http://www.evenheat-kiln.com/ceramic/technical/ Manufacturer's technical information]
-[[Category:Photographs Needed]]
 [[Category:Shop Equipment]]
 [[Category:Fabrication]]
 [[Category:Arts]]
 [[Category:Pottery]]