ShapeOko2 CNC Router: Difference between revisions
From Pumping Station One
| Line 40: | Line 40: | ||
** Do not over-tighten: if you over-tighten, the force can pull up the work surface. | ** Do not over-tighten: if you over-tighten, the force can pull up the work surface. | ||
* Check the envelope of the machine to ensure it will not crash into the rear dust guard - the grid of the work surface does not necessarily correspond to the grid in Easel. | * Check the envelope of the machine to ensure it will not crash into the rear dust guard - the grid of the work surface does not necessarily correspond to the grid in Easel. | ||
* The clamp down studs are 5mm. | |||
=== Collet & Bit Setup === | === Collet & Bit Setup === | ||
