Bridgeport Knee Power Feed: Difference between revisions
From Pumping Station One
m replaced burned-out drill |
m correct link to accessories cabinet |
||
| Line 11: | Line 11: | ||
|serial = n/a | |serial = n/a | ||
|arrived = 2017-09-25 | |arrived = 2017-09-25 | ||
|where = [[Large Mill Accessories Cabinet]] | |where = [[Bridgeport Knee Mill#In the Large Mill Accessories Cabinet|Large Mill Accessories Cabinet]] | ||
|doesitwork = yes | |doesitwork = yes | ||
|contact = [[User:mct|McTavish McArdle]] | |contact = [[User:mct|McTavish McArdle]] | ||
| Line 19: | Line 19: | ||
To enable future modification, the 3/8" square shank in the crank adapter is retained in the adapter body with a 1/4" x 1" dowel pin: the square shank is machined onto the end of a short section of 5/8" OD steel rod, which fits loosely (but closely) within the 5/8" ID shaft through the center of the crank. By machining a similar such feature onto the end of a similar section of rod, drilling an appropriate cross hole, & replacing the square shank, any number of drive mechanisms could be supported. | To enable future modification, the 3/8" square shank in the crank adapter is retained in the adapter body with a 1/4" x 1" dowel pin: the square shank is machined onto the end of a short section of 5/8" OD steel rod, which fits loosely (but closely) within the 5/8" ID shaft through the center of the crank. By machining a similar such feature onto the end of a similar section of rod, drilling an appropriate cross hole, & replacing the square shank, any number of drive mechanisms could be supported. | ||
[[Category:Loaned Equipment]] | |||
