Supermax 25x2 Drum Sander: Difference between revisions
From Pumping Station One
m Added authorized users list. |
mNo edit summary |
||
| Line 14: | Line 14: | ||
}} | }} | ||
= List of Currently Certified Users = | |||
{| class="wikitable" border="1" | {| class="wikitable" border="1" | ||
! Qualified Member | ! Qualified Member | ||
| Line 39: | Line 39: | ||
|Ralph Brendler | |Ralph Brendler | ||
|8.30.17 | |8.30.17 | ||
|- | |||
|[[User:Ekaj|Jake Snyder]] | |||
|Ralph Brendler | |||
|9/7/17 | |||
|} | |} | ||
| Line 68: | Line 72: | ||
*[http://www.supermaxtools.com/products/wood/25x2-double-drum-sander Manufacturer's Page] | *[http://www.supermaxtools.com/products/wood/25x2-double-drum-sander Manufacturer's Page] | ||
*[http://www.supermaxtools.com/wp-content/uploads/25x2_37x2-10-2015.pdf Owner's Manual] | *[http://www.supermaxtools.com/wp-content/uploads/25x2_37x2-10-2015.pdf Owner's Manual] | ||
Revision as of 18:51, 10 September 2017
 | |
| Owner/Loaner | PS:One |
|---|---|
| Serial Number | ? |
| Make/Model | 25x2 |
| Usability | yes |
| Contact | Eric Beauchamp |
| Where | Wood Shop |
| Authorization Needed | yes |
| Hackable | no |
| Estimated Value | $2700 |
| Host Area | Wood Shop |
List of Currently Certified Users
| Qualified Member | Trained By | Date |
|---|---|---|
| Eric Beauchamp | Danger committee | 6/23/2017 |
| Ralph Brendler | Danger committee | 6/23/2017 |
| Paul van Lake | Danger committee | 6/23/2017 |
| Zack Sasnow | Jason Shanfield | 8/27/17 |
| Justin Pestka | Ralph Brendler | 8.30.17 |
| Jake Snyder | Ralph Brendler | 9/7/17 |
Notes
- For oily or dense woods (tropical hardwoods, etc), take only very light passes to prevent clogging the sandpaper.
- Use a belt cleaner occasionally to refresh the sandpaper
Safety
This sander features overload detection. If the machine detects too high a load, it will automatically slow down the feed. This saves wear and tear on the machine, but may cause burning of the workpiece if you cut too aggressively.
- The height adjustment on this machine is VERY aggressive. A full turn will raise the table by more than 2mm (a typical cut should be < .5mm). PLEASE USE A MAXIMUM OF 1/8 TURN OF THE HEIGHT WHEEL PER PASS!
- Make your first cuts with a very slow speed (10 or less). Once you are sure the load is OK you can gradually increase the speed on subsequent passes.
- When overload detection kicks in, a red light next to the speed control will turn on. IF YOU SEE THIS LIGHT, PLEASE REDUCE YOUR DEPTH OF CUT AND/OR FEED RATE!
- Like all of our other sanders, sleeves must be above the elbow, and no gloves should be worn. It's pretty easy to get pulled into the rollers.
