Boss Laser Settings: Difference between revisions
From Pumping Station One
m →Known Settings: added engraving table, + more data |
m add link to boss |
||
| Line 1: | Line 1: | ||
The below is to help you figure out your settings for your cutting job. Please do not be creative with settings unless you know what you're doing, because you can easily set things on fire. | The below is to help you figure out your settings for your cutting job on the [[BOSS LS-3655 150w Laser Engraver|Boss Laser]]. Please do not be creative with settings unless you know what you're doing, because you can easily set things on fire. | ||
==Test Cuts== | ==Test Cuts== | ||
Revision as of 15:31, 30 September 2017
The below is to help you figure out your settings for your cutting job on the Boss Laser. Please do not be creative with settings unless you know what you're doing, because you can easily set things on fire.
Test Cuts
There are several test cut pieces. These test various power/speed in a pie shape going from 10% to 100%. These are a good starting point.
Known Settings
Known, successfully used settings.
Cutting
| Material | Thickness | Speed (mm/second) | Power (%) |
|---|---|---|---|
| Plywood | 1/4" | 25? | 80 |
| ABS | 1/8" | 20 | 65 |
| Cermark Engraving Brass | 30 | 70 | |
| Masonite | 1/8" | 15 | 50 |
Engraving
| Material | Depth | Speed (mm/second) | Power (%) |
|---|---|---|---|
| Masonite | 0.4mm | 100 | 10 |
| Masonite | 1mm | 100 | 15 |
| Masonite | 1.3mm | 100 | 20 |
| Masonite | 1.6mm | 100 | 25 |
