Supermax 25x2 Drum Sander

Supermax 25x2 Drum Sander

Owner/Loaner	PS:One
Serial Number	?
Make/Model	25x2
Usability	yes
Contact	Eric Beauchamp
Where	Wood Shop
Authorization Needed	yes
Hackable	no
Estimated Value	$2700
Host Area	Wood Shop

Qualified Member	Trained By	Date
Eric Beauchamp	Danger committee	6/23/2017
Ralph Brendler	Danger committee	6/23/2017
Paul van Lake	Danger committee	6/23/2017
Zack Sasnow	Jason Shanfield	8/27/17

Notes

• For oily or dense woods (tropical hardwoods, etc), take only very light passes to prevent clogging the sandpaper.

• Use a belt cleaner occasionally to refresh the sandpaper

Safety

This sander features overload detection. If the machine detects too high a load, it will automatically slow down the feed. This saves wear and tear on the machine, but may cause burning of the workpiece if you cut too aggressively.

• The height adjustment on this machine is VERY aggressive. A full turn will raise the table by more than 2mm (a typical cut should be < .5mm). PLEASE USE A MAXIMUM OF 1/8 TURN OF THE HEIGHT WHEEL PER PASS!

• Make your first cuts with a very slow speed (10 or less). Once you are sure the load is OK you can gradually increase the speed on subsequent passes.

• When overload detection kicks in, a red light next to the speed control will turn on. IF YOU SEE THIS LIGHT, PLEASE REDUCE YOUR DEPTH OF CUT AND/OR FEED RATE!

• Like all of our other sanders, sleeves must be above the elbow, and no gloves should be worn. It's pretty easy to get pulled into the rollers.

Outside Links

• Manufacturer's Page
• Owner's Manual