Mitsui Surface Grinder: Difference between revisions
From Pumping Station One
Stop stealing grinders from Dean |
|||
| Line 15: | Line 15: | ||
Motor bearings were replaced, to great success. | Motor bearings were replaced, to great success. | ||
Ball ways and table are installed. The test grind on 4140PH went well. Good finish with no ripples. | |||
# | # Remove saddle, clean ways and check turcite for damage. | ||
# Z ways need to be cleaned. | # Z ways need to be cleaned. | ||
# | # Replace Z way pleated covers. | ||
# Fill lubrication tank with correct oil. Check that all oil lines are working. | |||
== Diagnosis == | == Diagnosis == | ||
