Shop Fox 8" Plate Shear: Difference between revisions
From Pumping Station One
No edit summary |
mNo edit summary |
||
| Line 30: | Line 30: | ||
[[Category:Fabrication]] | [[Category:Fabrication]] | ||
[[Category:Cold Metals]] | [[Category:Cold Metals]] | ||
[[Category:Loaned Equipment]] | |||
Revision as of 10:49, 16 August 2017
 | |
| Owner/Loaner | Michael Skilton |
|---|---|
| Serial Number | {{{serial}}} |
| Make/Model | M1040 |
| Arrival Date | 2013 |
| Usability | yes |
| Contact | Michael Skilton |
| Where | Cold Metals |
| Authorization Needed | No |
| Hackable | No |
| Estimated Value | $100 |
| Host Area | {{{hostarea}}} |
Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.
