ShapeOko2 CNC Router: Difference between revisions
From Pumping Station One
No edit summary |
No edit summary |
||
| Line 40: | Line 40: | ||
1. Waste board repaired or replaced. Entire board is unsupported in the middle, causing it to sag. Also, one stud has pulled up a volcano-like mountain in one part of the waste board, and needs to be milled down. Recommend getting two $7 20mmx20mmx300mm extrusions (from Inventables or elsewhere) and T-nuts to support it in the middle (this is a common upgrade for this particular machine). | 1. Waste board repaired or replaced. Entire board is unsupported in the middle, causing it to sag. Also, one stud has pulled up a volcano-like mountain in one part of the waste board, and needs to be milled down. Recommend getting two $7 20mmx20mmx300mm extrusions (from Inventables or elsewhere) and T-nuts to support it in the middle (this is a common upgrade for this particular machine). | ||
2. Bearing blocks on all axis need to be tuned. Some are not making contact, | 2. Bearing blocks on all axis need to be tuned. Some are not making contact, gantry is not square to waste board, and spindle is not square either. | ||
3. Spindle PWM, both power supplies, and perhaps the GRBLShield should be mounted in a compact, fan-cooled enclosure. I'd love said enclosure to be part of a full machine enclosure that incorporates noise suppression, interior lighting, and dust collection. | 3. Spindle PWM, both power supplies, and perhaps the GRBLShield should be mounted in a compact, fan-cooled enclosure. I'd love said enclosure to be part of a full machine enclosure that incorporates noise suppression, interior lighting, and dust collection. | ||
4. | 4. Finish Programming Homing and limit switches. This should prevent some crashes. | ||
5. General wiring clean-up and sheathing: some connectors have bare leads exposed, and I'd love to clean up the build by sheathing many of the wires. | 5. General wiring clean-up and sheathing: some connectors have bare leads exposed, and I'd love to clean up the build by sheathing many of the wires. | ||
== Documentation == | == Documentation == | ||
| Line 111: | Line 110: | ||
| [[User:esp | Jeremy fay]] | | [[User:esp | Jeremy fay]] | ||
| [[User:ad9581 | Arturo Duarte]] | | [[User:ad9581 | Arturo Duarte]] | ||
|- | |||
| [[User:dannyblanchard | Danny Blanchard]] | |||
| [[User:rtystgeeke | Andrew Camardella]] | |||
|- | |- | ||
|} | |} | ||
[[Category:Fabrication]] | [[Category:Fabrication]] | ||
