Vote to Enhance Dust Collection: Difference between revisions

Browse history interactively

← Older edit Newer edit →

VisualWikitext

@@ Line 13: / Line 13: @@
 I suggest we do the following:
-) Replace the two filters in the Clearvue cyclone filter stack.  $165 each from Wynn.
+# Replace the two filters in the Clearvue cyclone filter stack.  $165 each from Wynn.
-) Enclose the collector rack with an acoustic barrier. Add a muffler to the exhaust.
+# Enclose the collector rack with an acoustic barrier. Add a muffler to the exhaust.
-) Automate the blast gates.  When a machine is turned on, the blast gate (valve in the duct) will open and stay open for a few seconds.
+# Automate the blast gates.  When a machine is turned on, the blast gate (valve in the duct) will open and stay open for a few seconds.
-) Replace the fine dust bin below the filter stack  with a wood bin tall enough to support the stack without the orange bucket. The goals are to add dust holding capacity and support the stack more securely.
+# Replace the fine dust bin below the filter stack  with a wood bin tall enough to support the stack without the orange bucket. The goals are to add dust holding capacity and support the stack more securely.
-) Add more equipment to the collection system. The new bandsaw, jointer, router table and sanders should be added.
+# Add more equipment to the collection system. The new bandsaw, jointer, router table and sanders should be added.
-) Add more dust collection capacity.  The Clearvue system can support 2 or sometimes 3 simultaneously running machines.  When the shop is busy, we exceed this.
+# Add more dust collection capacity.  The Clearvue system can support 2 or sometimes 3 simultaneously running machines.  When the shop is busy, we exceed this.
-) Add overhead dust collection to the sawstop.  This was in the original dust collection vote, but we didn't get it due to a long lead time on the part.  http://www.thesharkguard.com/sharkdc.php
+# Add overhead dust collection to the sawstop.  This was in the original dust collection vote, but we didn't get it due to a long lead time on the part.  http://www.thesharkguard.com/sharkdc.php
-) Flow sensor to the duct and pressure sensors before and after the cyclone.
+# Flow sensor to the duct and pressure sensors before and after the cyclone.
-) Bin level sensors for the cyclone bin and the filter stack bin.
+# Bin level sensors for the cyclone bin and the filter stack bin.
-) Enclose the filter stack so we can apply a burst of pressure to clean the filter.
+# Enclose the filter stack so we can apply a burst of pressure to clean the filter.
-) Better filter/small cyclone for the Jet dust collector.
+# Better filter/small cyclone for the Jet dust collector.
 == Language ==