Epilog 30w Mini 24 Laser Engraver: Difference between revisions
From Pumping Station One
Naa, nobody needs to touching firmware settings. The default is on and should stay that way. |
No edit summary |
||
| Line 60: | Line 60: | ||
Check the regulator for accumulated water from time to time. Place a container (and maybe some paper towels) under the regulator and vent accumulated water from the bottom using the small petcock. If too much water accumulates in the regulator, it may flow through the air hose and into the machine, spraying onto the bed/material. | Check the regulator for accumulated water from time to time. Place a container (and maybe some paper towels) under the regulator and vent accumulated water from the bottom using the small petcock. If too much water accumulates in the regulator, it may flow through the air hose and into the machine, spraying onto the bed/material. | ||
== Cleanup == | |||
Please leave the machine cleaner than you found it by emptying the crumb tray below the cutting table, picking up cutouts, and vacuuming up any acrylic dust you made. | |||
== '''NEVER CUT THESE MATERIALS''' == | == '''NEVER CUT THESE MATERIALS''' == | ||
