MakerBot Replicator: Difference between revisions

@@ Line 13: / Line 13: @@
 }}
-== Status ==
+== To Fix or Verify ==
+*Heat bed is partially removed, someone soldered some of the connectors onto the board. Determine if replacement board works with the original connector.
+*Does it turn on and everything heat up?
+*Are any of the extruders currently jammed?
+*Level nozzles.
+*Level bed.
+== Current Status ==
 February 20, 2015: Left extruder working, right extruder not feeding properly.
-August 28, 2014: Both extruders working, but periodically jamming. See the "Clearing a Filament Jam" video on Makerbot's maintenance page for the Replicator . http://www.makerbot.com/support/replicator/documentation/maintenance/
-August 3, 2014: Both extruders working, both nozzles replaced. Bed way out of level.
-June 30, 2014: <s>Missing one bed-leveling knurled nut.</s> (This is the normal state of the machine - the argument being that the bed is significantly easier to level with only three points. The newest machines from makerbot feature only three leveling points from the factory)
+== Notes ==
+*Only 3 bed leveling nuts are installed because it is significantly easier to level with only three points. The newest machines from Makerbot feature only three leveling points from the factory.
+*Both extruders working, but periodically jamming. See the "Clearing a Filament Jam" video on Makerbot's maintenance page for the Replicator . http://www.makerbot.com/support/replicator/documentation/maintenance/
 == References ==