Vacuum table: Difference between revisions
From Pumping Station One
Created page with "{{Template:EquipmentPage |owner = Khoi Nguyen |certification=yes |hackable = NO |model = |serial = |arrived = Dec 2014 |doesitwork = yes |contact = Khoi Nguyen |where = Wood..." |
No edit summary |
||
| Line 3: | Line 3: | ||
|certification=yes | |certification=yes | ||
|hackable = NO | |hackable = NO | ||
|model = | |model = N/A | ||
|serial = | |serial = N/A | ||
|arrived = Dec 2014 | |arrived = Dec 2014 | ||
|doesitwork = yes | |doesitwork = yes | ||
|contact = Khoi Nguyen | |contact = Khoi Nguyen | ||
|where = Woodshop Under Worktable | |where = Woodshop Under Worktable | ||
|value = $ | |value = $500.00 | ||
|image = VacuumTable.jpg | |image = VacuumTable.jpg | ||
}} | }} | ||
== General == | |||
This is a | |||
== Rules == | == Rules == | ||
# Use for Large flat objects, | # Use for Large flat objects or small delicate objects, '''Not''' for glueing dimensional lumber | ||
# ALWAYS Check | #* If clamps can be used to achieve your goal, please use them instead | ||
# '''ALWAYS''' Check for sharp edges on your work pieces, as they can puncture (read: ruin) the bag | |||
#*use the extra piece of plastic over any work piece that you are gluing or has sharp corners | |||
#*it is best to sand or otherwise smooth all corners of your work piece as well | |||
#Check to make sure that the vacuum has stabilized at 21 before you leave your work unattended for curing time | |||
#*if the vaccum does not turn off after 10-15 minutes of run time there may be a leak | |||
== List of Currently Certified Users == | == List of Currently Certified Users == | ||
Revision as of 11:31, 17 December 2014
 | |
| Owner/Loaner | Khoi Nguyen |
|---|---|
| Serial Number | N/A |
| Make/Model | N/A |
| Arrival Date | Dec 2014 |
| Usability | yes |
| Contact | Khoi Nguyen |
| Where | Woodshop Under Worktable |
| Authorization Needed | yes |
| Hackable | NO |
| Estimated Value | $500.00 |
| Host Area | {{{hostarea}}} |
General
This is a
Rules
- Use for Large flat objects or small delicate objects, Not for glueing dimensional lumber
- If clamps can be used to achieve your goal, please use them instead
- ALWAYS Check for sharp edges on your work pieces, as they can puncture (read: ruin) the bag
- use the extra piece of plastic over any work piece that you are gluing or has sharp corners
- it is best to sand or otherwise smooth all corners of your work piece as well
- Check to make sure that the vacuum has stabilized at 21 before you leave your work unattended for curing time
- if the vaccum does not turn off after 10-15 minutes of run time there may be a leak
List of Currently Certified Users
| Qualified Member | Trained By |
|---|---|
| Khoi Nguyen | Owner |
| Will Garza | Khoi Nguyen |
