Shop Fox 8" Plate Shear: Difference between revisions
From Pumping Station One
switching to a template |
fixing broken fields |
||
| Line 2: | Line 2: | ||
| owner = Michael Skilton | | owner = Michael Skilton | ||
| model = M1040 | | model = M1040 | ||
| | | doesitwork = Working | ||
| contact = Michael Skilton | | contact = Michael Skilton | ||
| where = Machine Shop | | where = Machine Shop | ||
| Line 8: | Line 8: | ||
| hackable = No | | hackable = No | ||
| value = $100 | | value = $100 | ||
| arrived = 2013 | |||
}} | }} | ||
Revision as of 21:43, 2 September 2013
 | This tool is currently broken, please contact the area host for more information. |
| Owner/Loaner | Michael Skilton |
|---|---|
| Serial Number | {{{serial}}} |
| Make/Model | M1040 |
| Arrival Date | 2013 |
| Usability | Working |
| Contact | Michael Skilton |
| Where | Machine Shop |
| Authorization Needed | No |
| Hackable | No |
| Estimated Value | $100 |
| Host Area | {{{hostarea}}} |
Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.
