Shop Fox 8" Plate Shear: Difference between revisions
From Pumping Station One
No edit summary |
No edit summary |
||
| (11 intermediate revisions by 6 users not shown) | |||
| Line 1: | Line 1: | ||
{{Template:EquipmentPage | |||
| owner = Michael Skilton | |||
| model = M1040 | |||
| doesitwork = yes | |||
| contact = Michael Skilton | |||
| where = | |||
| certification = No | |||
| hackable = No | |||
| value = $100 | |||
| arrived = 2013 | |||
|image = Shop Fox plate shear.jpg | |||
}} | |||
= Removed by owner 3/13/20 = | |||
== Note == | == Note == | ||
Primarily designed for straight cuts in sheet metal. | Primarily designed for straight cuts in sheet metal. | ||
| Line 41: | Line 31: | ||
[[Category:Retired Equipment]] | |||
Latest revision as of 15:49, 13 March 2020
 | |
| Owner/Loaner | Michael Skilton |
|---|---|
| Serial Number | {{{serial}}} |
| Make/Model | M1040 |
| Arrival Date | 2013 |
| Usability | yes |
| Contact | Michael Skilton |
| Authorization Needed | No |
| Hackable | No |
| Estimated Value | $100 |
| Host Area | {{{hostarea}}} |
Removed by owner 3/13/20
Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.
