Peristaltic pump controller: Difference between revisions
From Pumping Station One
No edit summary |
mNo edit summary |
||
| (4 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{Template:EquipmentPage | {{Template:EquipmentPage | ||
|owner = Ryan Pierce | |owner = Ryan Pierce | ||
| Line 8: | Line 6: | ||
|serial = Unknown | |serial = Unknown | ||
|arrived = November, 2012 | |arrived = November, 2012 | ||
|doesitwork = | |doesitwork = yes | ||
|contact = Ryan Pierce | |contact = Ryan Pierce | ||
|where = [[Beer Church]] | |where = [[Beer Church]] | ||
|value = $140 | |value = $140 | ||
}} | }} | ||
== Operation == | |||
TODO: write up properly. For now, just hints: | |||
Make sure to screw on the retainer clamp... but not too tight. It's only there to prevent the tubing from walking in the housing, which can cause it to get eaten up. Do'nt clamp it so hard it leaves marks. When you're done using the pump remove the tubing shortly thereafter, leaving it clamped can dent the tubing permanently. | |||
== Accessories == | == Accessories == | ||
| Line 32: | Line 36: | ||
|Ryan Pierce | |Ryan Pierce | ||
|} | |} | ||
[[Category:Brewing]] | |||
[[Category:Photographs Needed]] | |||
[[Category:Loaned Equipment]] | |||
