Tormach CNC Plasma Cutter Debugging: Difference between revisions

@@ Line 3: / Line 3: @@
 Check
-. Is the blue light on the button by the power switch?
+# Is the blue light on the button by the power switch?
-. Did you hit the reset button in pathpilot?
+# Did you hit the reset button in pathpilot?
-. Does the torch move on the Z axis?
+# Does the torch move on the Z axis?
-. Is the "Machine OK" status light on?
+# Is the "Machine OK" status light on?
-. Did you reference X, Y and Z?
+# Did you reference X, Y and Z?
+Known issue with the MrFluffles post processor as of May 4 2023. Updated August 22, 2023
+The post-processor is adding feed speed, cut height and a dwell command after the M200 command. This overrides the settings of the AutoFS stock picker in Pathpilot.
+If you picked the correct tool/settings for your material in Sheetcam this shouldn't be an issue. However, using the same Gcode for different materials will likely lead to less-than-optimal cuts. The extra dwell after the pierce operation (G16) can be eliminated by setting the pierce delay in Sheetcam to zero.