Supermax 25x2 Drum Sander: Difference between revisions
From Pumping Station One
No edit summary |
removed equipment |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
|serial=? | |serial=? | ||
|arrived= | |arrived= | ||
|doesitwork= | |doesitwork=Yesu | ||
|contact=[[user: | |contact=[[user: samparis|Sam Paris]] | ||
|where= | |where=Removed | ||
|certification=yes | |certification=yes | ||
|hackable=no | |hackable=no | ||
| Line 15: | Line 15: | ||
== Status == | == Status == | ||
=Ths asset is being removed from PS:1= | |||
Needs jamb nuts 1/6/2022 | Needs jamb nuts 1/6/2022 | ||
| Line 45: | Line 47: | ||
*Do not use to remove old finishes. | *Do not use to remove old finishes. | ||
=== Abrasive Dimensions === | |||
If you need to cut a new abrasive from the roll and tracing the old one isn't convenient, use the dimensions below. | |||
[[File:Supermax 25x2 abrasive dimension.png]] | |||
(not to scale!) | |||
# From one square cut edge, measure 12' and cut another square edge. You now have a strip of abrasive 144" long and 4" wide. | |||
# Measure 13.5" from one end and make a mark on the back of the paper. Trace this line to the nearby end's opposite corner, making a diagonal. This 13 1/2" x 4" right triangle defines the first "tail." Cut along this diagonal to make the first end pointy. | |||
# Measure 3.5" from the point. Draw a line perpendicular to the diagonal edge. Cut this off to make the pointy end stubby. | |||
# Repeat this procedure on the other end **but on the opposite edge.** That is, make a (blunted) rhombus, not a trapezoid. You now have two tails on your long strip, one "facing up" and one "facing down." | |||
# Refer to the video on how to install this into the machine. | |||
== Safety == | == Safety == | ||
| Line 83: | Line 98: | ||
|- | |- | ||
|} | |} | ||
[[Category: | [[Category:Removed Equipment]] | ||
