Mitsui Surface Grinder: Difference between revisions
From Pumping Station One
Current status |
Tachoknight (talk | contribs) No edit summary |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
|model=Mitsui 250MH | |model=Mitsui 250MH | ||
|arrived=Late 2016 | |arrived=Late 2016 | ||
|doesitwork= | |doesitwork=no | ||
|contact=Dean Anderson | |contact=Dean Anderson | ||
|where= | |where=Removed | ||
|certification=yes | |certification=yes | ||
|hackable=no | |hackable=no | ||
|value=~$3000 | |value=~$3000 | ||
|hostarea= | |hostarea= | ||
}} | }} | ||
Removed by owner | |||
== Repair and Setup== | == Repair and Setup== | ||
| Line 53: | Line 56: | ||
The two table ball cages need to be removed anytime the grinder is moved. This is necessary to prevent the races from Brinelling. To remove the ball cages, disconnect the X axis cable at each end of the table then prop up the ends of the table. | The two table ball cages need to be removed anytime the grinder is moved. This is necessary to prevent the races from Brinelling. To remove the ball cages, disconnect the X axis cable at each end of the table then prop up the ends of the table. | ||
[[Category:Loaned Equipment]] | |||
