48in sheet metal brake: Difference between revisions
From Pumping Station One
m removed Category:Photos Needed |
No edit summary |
||
| (10 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
{{Template:EquipmentPage | {{Template:EquipmentPage | ||
|image=48in_sheet_metal_brake.jpg | |image=48in_sheet_metal_brake.jpg | ||
|owner=PS:One | |owner=PS:One | ||
|model=Sheet Metal Brake | |model=Sheet Metal Brake | ||
|arrived=Feb 2013 | |||
|doesitwork= | |doesitwork=yes | ||
|contact= | |contact=Dean Anderson (Area Host) | ||
|where= | |where=Cold Metals | ||
|certification= no | |certification=no | ||
|hackable=no|value=$750.00}}<br> | |hackable=no | ||
|value=$750.00 | |||
|hostarea=Cold Metals | |||
}}<br /> | |||
== Use == | == Use == | ||
For straight line bends in sheet metal. Up to 16 gauge?<br> | For straight line bends in sheet metal. Up to 16 gauge?<br /> | ||
== Note == | == Note == | ||
When moving the teeth, make sure the dogs on the back are vertical. If they are hanging on by a corner they may fall off and get damaged.<br> | When moving the teeth, make sure the dogs on the back are vertical. If they are hanging on by a corner they may fall off and get damaged.<br /> | ||
{{Template:Training|links=<br />[http://www.sheetmetalguy.com/bend-allowance.htm Bend Allowance]<br />[http://www.brighthub.com/engineering/mechanical/articles/38675.aspx The Art of Sheet Metal Design]}} | |||
==maintenance== | |||
the mainteance page is [[48in_sheet_metal_brake_maintenance|here]] | |||
[[Category:Shop Equipment]] | |||
[[Category:Fabrication]] | |||
[[Category:Cold Metals]] | |||
