Shop Fox 8" Plate Shear: Difference between revisions
From Pumping Station One
No edit summary |
No edit summary |
||
| (6 intermediate revisions by 5 users not shown) | |||
| Line 2: | Line 2: | ||
| owner = Michael Skilton | | owner = Michael Skilton | ||
| model = M1040 | | model = M1040 | ||
| doesitwork = | | doesitwork = yes | ||
| contact = Michael Skilton | | contact = Michael Skilton | ||
| where = | | where = | ||
| certification = No | | certification = No | ||
| hackable = No | | hackable = No | ||
| Line 11: | Line 11: | ||
|image = Shop Fox plate shear.jpg | |image = Shop Fox plate shear.jpg | ||
}} | }} | ||
= Removed by owner 3/13/20 = | |||
== Note == | == Note == | ||
| Line 28: | Line 30: | ||
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut. | Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut. | ||
[[Category: | [[Category:Retired Equipment]] | ||
