Prusa i3 OctoPrint Server: Difference between revisions
From Pumping Station One
Creating OctoPrint equipment page |
|||
| (11 intermediate revisions by 3 users not shown) | |||
| Line 10: | Line 10: | ||
|where = [[CNC]] 1st Floor | |where = [[CNC]] 1st Floor | ||
|value = $50 | |value = $50 | ||
|image = | |image = Prusa i3 OctoPrint Server.jpeg | ||
|hostarea = CNC | |hostarea = CNC | ||
}} | }} | ||
== IP Address == | |||
http://10.100.1.203/ is the "middle" Prusa as of December 4, 2018, and has a broken SD card reader. You must use Octoprint to print. | |||
== Current Status == | == Current Status == | ||
Offline. | |||
== Authorization == | |||
Authorization for this device is determined by authorization for the [[Prusa i3 3D printer]]. | |||
== Operation == | |||
Please see [[Prusa i3 3D printer#Prusa i3 OctoPrint Server]] | |||
== Recommended Non-Stock Plugins == | |||
* Slicer (1.2.5) | |||
** A full-blown GUI-based slicer. Rotate and scale model; set layer height and other critical parameters. | |||
== See Also == | |||
* [[Prusa i3 3D printer]] | |||
* [[Lulzbot Taz3]] | |||
* [[Taz 3 OctoPrint Server]] | |||
