User:Mct/space-projects: Difference between revisions
From Pumping Station One
m →things: add wrench detail |
m →outdated: mark comments out with parens |
||
| (5 intermediate revisions by the same user not shown) | |||
| Line 6: | Line 6: | ||
* [[User:mct/wiki-todo|wiki cleanup]] | * [[User:mct/wiki-todo|wiki cleanup]] | ||
* [[User:mct/flammables-cabinet-cleanup|flammables cabinet cleanup]] | * [[User:mct/flammables-cabinet-cleanup|flammables cabinet cleanup]] | ||
== outdated == | |||
''archived project pages that are no longer relevant to the current state of the shop'' | |||
* [[User:Mct/surface-grinder-setup-todo|surface grinder setup]] (''surface grinder is up & running'') | |||
= things = | = things = | ||
| Line 17: | Line 22: | ||
** can be affixed to cabinets / tool carts / shelves to show little charts of when they were last thoroughly organized | ** can be affixed to cabinets / tool carts / shelves to show little charts of when they were last thoroughly organized | ||
** idea is to provide a decentralized, low-overhead means of coordinating contents organization / cleanup | ** idea is to provide a decentralized, low-overhead means of coordinating contents organization / cleanup | ||
* modular table covers for the bridgeport | |||
** modules | |||
*** idea is to have them be in sections of 4-10" so they can accommodate the vice moving, &c | |||
**** make multiple sizes, so they can be rearranged? | |||
*** will need at least two special ones to fit snugly against vice sides, which aren't square | |||
*** should have magnets in, so they stick to the table | |||
*** blocks that fit (loosely?) into the t-slots, so they register easily | |||
** manufacture | |||
*** will have to laser-cut, to get the contours for the vice-hugging sections right | |||
*** engrave holes for magnets & mark out t-slot block positions | |||
*** screw / glue / staple t-slot blocks down? | |||
**** top surface should be flat, so would need to countersink screws carefully | |||
** material | |||
*** maso or mdf would be easiest | |||
*** plastic (hdpe?) for wear / oil resistence? | |||
* convert one of the two spindexers into a powered cylindrical grinding fixture for the [[Boyer Schultz 6-12 Surface Grinder|surface grinder]] | |||
** mount motor, add round belt pulley to spindle | |||
** add thrust bearing to preload spindle | |||
** big thick base so the spindexer doesn't need to sit in the middle of the mag chuck | |||
** will probably need to make a pin spanner to tighten the front screw on | |||
* tool height gauge for the [[Clausing Lathe|clausing]] | |||
** mag base to make it easy to mount solidly on the ways? | |||
** use dowel pin for reference surface | |||
*** grind to proper dimension | |||
** need good way to experimentally determine proper tool height | |||
