AlarmLock PDL3000: Difference between revisions
From Pumping Station One
creating door lock page |
|||
| (16 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
{{Template:EquipmentPage | {{Template:EquipmentPage | ||
| | |owner = PS:One | ||
| model = PDL3000 | |model = PDL3000 | ||
| hackable = | |hackable = yes | ||
| where = Installed on Front Door | |certification = yes | ||
|where = Installed on Front Door | |||
|value = ~$1000 | |||
|doesitwork = yes | |||
}} | }} | ||
== Getting an Access Code == | |||
In order to get the access code, you should A: be a paying member in good standing with the organization, and B: have your [[Bylaws#Eligibility|id checked]] by 2 board members. The best time to get your ID checked is at a general meeting which occur every Tuesday at 8:00pm. | |||
== Reprogramming the Lock == | |||
The full manual is available at http://www.alarmlock.com/images/pdf/ETPDL_PDL3X00_WI1021C.07_PROG.pdf | |||
* The document may not render the keypad font correctly, making the document useless. | |||
** It fails to render correctly in firefox, and OS X's preview application. | |||
** It renders correctly in [https://get.adobe.com/reader/ Adobe Reader] for OS X. | |||
** It renders correctly in Chrome. | |||
== Sharing the door code == | |||
* Please don't share the door code with non-members | |||
* If you don't have the ability to verify membership status, please don't give out the door code. | |||
== Changing the door code == | |||
Door code logic: each allowed code is associated with a user id between the numbers 12 and 50, inclusive. | |||
The door codes are documented on a ''User Code Record Sheet'' that is stored in the safe. | |||
=== Programming the door === | |||
To program the door, enter programming mode and enter function codes. All function codes take the form <code>A {function code} (A params) *</code>. While programming mode is enabled, the door will beep every few seconds. You may enter functions until you exit programming mode. To Exit Programming mode, hold down any button for 3 seconds. | |||
<code>{MASTER CODE} A</code> | |||
You are now in program mode until you hold a button for 3 seconds. | |||
==== Adding ==== | |||
<code>A 2 A {User ID} A {CODE} *</code> | |||
==== Deleting ==== | |||
<code>A 2 A {USER ID} *</code> | |||
==== Temporarily Unlocking ==== | |||
<code>A 47 A {HOURS} *</code> | |||
== Erasing All Programing == | |||
# Remove battery | |||
# Hold down A for 10 seconds (drain the capaciters) | |||
# Reinstall Battery | |||
# withing 5 seconds of hearing 3 beeps, Hold A until it beeps more | |||
# The lock is now reset, the master programming code is now the default. | |||
