View source for Jointer Grizzly 8 inch

{{Template:EquipmentPage
|owner = PS1
|certification=yes
|hackable = yes
|model = Grizzly G0495X 
|serial = 188557
|arrived = DEC 2019
|doesitwork = yes
|contact = Wood Shop Area Host
|where = Wood Shop
|value = $525.00
|hostarea = Wood Shop
|image = G0495x.jpg
}}{{:Authorizations/Woodshop Basic}}
== Status ==

Good to go.

== Rules ==
# Always check your wood for nails or staples. If you're not sure, check the entire piece with the metal detector or a magnet.
# Remove the smallest amount of material possible and feed it at an appropriate speed. More passes are better than fewer. If you don't know how to properly adjust the infeed table, ask for help.
# Always use the vacuum while running the jointer. Otherwise, it will clog with chips.
# If you break something, or damage the tool, contact the area host immediately. Don't let others do more damage to the machine, ruin their work, or hurt themselves by using a broken tool.
# Always vacuum the machine, cutting area, and the table around the machine when you are done.

==Maintenance Notes==
*The pulley on the cutterhead spindle likes to walk off. Grizzly had a long lead time on the part, so we replaced with McMaster 6204K135. That part needed to be turned down to fit.

[[Category:Shop Equipment]]
[[Category:Wood Shop]]
[[Category:Loaned Equipment]]